This is video of Arduino Timer with few functions
Code Based on This Theory: lesson-10-timer-example-code
It works like this:
1. You choose by Jumper pins – if it will count Seconds or Minuets (Pins 2 and 3 – if connected to GND => chosen)
2. You move Potentiometer to decide number between 0-100 (Sec. or Minutes) – you see the number on Serial PORT
2. You choose in SW if it will be OFF and AFTER TIME ON, or ON and After time OFF
3. You give “START” command by connecting PIN 4 – to GND
4. The output (RELAY or LED out) is pin number 7
To support my site use the links below to order Thanks!
Aliexpress
Arduino Nano: https://bit.ly/3953j2p
Arduino Pro mini: https://bit.ly/2XdXfiL
Arduino Uno: https://bit.ly/3orcm4s
Arduino Mega: https://bit.ly/2Mzodix
Arduino Shield LCD: https://bit.ly/2XgeqQB
Arduino Micro: https://bit.ly/2LtGn4F
Arduino Leonardo: https://bit.ly/3njYtU4
Amazon:
Arduino Uno: https://amzn.to/35jkxIu
Arduino Pro mini: https://amzn.to/3hUVr7J
Arduino Nano: https://amzn.to/35g5IX2
Arduino Mega: https://amzn.to/2KZ5DAg
Arduino LCD shield: https://amzn.to/3opHVvi
Arduino Micro: https://amzn.to/3pVHs4e
Arduino Leonardo: https://amzn.to/2Xj5J8h
Ebay link to Buy Arduino Mega: [adsenseyu2]
Ebay link to Buy Arduino Uno: [adsenseyu3]
Ebay link to bu Arduino Nano: [adsenseyu4]
[adsenseyu1]